GI barrel vise and receiver wrench drawings?

[M1Garandy]

Anyone have a copy of the Ordnance drawings for the barrel vise and receiver wrench used with the M1903?

I know the receiver wrench drawing is RIA drawing number B31601 but I do not know the drawing number for the barrel vise.

Thanks.

[Emri]

I don't know if they are in here or not, take a look.

http://www.jouster.com/forums/showthread.php?31868-source-for-1903-dimentional-data


HTH,

Emri

[M1Garandy]

I'll have to spend some time tonight looking through that link. Lots of stuff! I know the reciever wrench drawing is in Brophys book but I do not have access to a copy.

[chuckindenver]

neet,,,but nothing on the tools..
i can tell you what they used at the factory is not the same as what they used at the repair level.
my vise is a G.I. issue screw type barrel vise, i had to make the blocks..my action wrench is a beast at 50 pounds..
id bet its the same type used to install 1917 barrels..very simple and basic.