PDA

View Full Version : 22 scope mount question



glindes
01-03-2014, 02:22
Gents, et al:

Years ago, I purchased a custom 1" aluminum 22 scope mount from someone on this thread.

I've found the mount and forgotten what gun it was for...

It is a custom 1" scope mount elevated (not offset right or left) either for a H&R Model 12 (or Remington or Mossberg) trainer being offered by the CMP at the time...

It came with an Allen wrench for the telescope mount screws and an Allen screw for the custom
mount. the recommended front mount was a 1" Tasco aluminum ring mount for 22's/airguns (I have this)

Does anyone remember which weapon?
Can/would you post a pic(s) of installed mount and scope?

RSVP Thanks Geoff

n64atlas
01-04-2014, 02:09
Ken Vianni {sic} made mounts that used the rear barrel mount holes and the receiver sight holes. He made them for several of the trainers that the CMP released.
Could be for any of hem. It depends on what you had at that time. It could also have been a one off type mount also. Can you post pics?

glindes
01-04-2014, 02:05
Normally, yes. Camera software in laptop not working...we'll get it yet...