PDA

View Full Version : RIA/ArmsCor Work in Progerss



Richard H Brown Jr
11-17-2015, 11:53
Just a note:

Playing with my RIA full size 1911a1 last week, ran a box of no-name (50) thru it at an indoor range. Went and did a full detail strip and had problems due to the tightness of the wee beastie in putting it back together. My bad. My 70+ yr old Remington Rand 1911a1 goes together so easily I'm jaded. But I did find out that the Hammer looks like it was a MIM (Metal Injection Moulding) piece. Because the surface where the sear mates, during full cock, is rounded over. So a call into Sarco and Numrich for bits of N.O.S. (hammer, hammer pin, and hammer strut). For my local 1911 master to put in for me.

RHB

Richard H Brown Jr
11-21-2015, 11:47
Progress report:

Sarco delivered the pin kit,spring kit, and wear out kit, now all I'm waiting on is Numrich and the hammer strut. *sigh*

RHB