PDA

View Full Version : Blue Dot in .357 Mag.



RED
01-05-2016, 03:50
Since Alliant 2400 powder is simply not available around here, I have been diddling with Alliant Blue Dot and Hodgdon 110

Ponder this: Why are the start/maximum loads for pistols bigger than than for rifles?

From the latest Sierra manual:

.357 pistol loads for Blue dot behind 158 gr. JSP. Start- 11.6 Max. 12.6

.357 rifle loads for Blue dot behind 158 gr. JSP. Start- 10.0 Max. 11.2
__________________________________________________ _____

Hornady loads (from Loadbooks)

.357 pistol loads for H-110 behind HP-XTP 158 gr. Start- 12.7 Max* 15.6

.357 rifle loads for H-110 behind HP-XTP 158 gr. Start- 8.6 Max* 15.5

*Note 4.1gr. difference in starting loads

joem
01-05-2016, 05:50
Only thing that comes to mind would be barrel length that might build more pressure. I've been using AA # 9 lately as I have plenty.

PhillipM
01-05-2016, 09:08
I'm just guessing, but if the handgun is a revolver it has a much bigger jump to the rifling and has the barrel to cylinder gap to reduce pressure.

Sunray
01-05-2016, 10:07
"...Ponder this:..." the real question is why does Hodgdon say to use magnum primers for H110 in a .357, but not a .30 Carbine. snicker.

Matt Anthony
01-05-2016, 10:18
Powder has a longer burn time in the rifle.
Mattg hi

emmagee1917
01-06-2016, 08:05
Magnum pistol vs. non-magnum rifle . Different critters .
Chris

Tuna
01-06-2016, 08:26
And the primers are about the same as to there ability to shatter and ignite the powder. Small magnum pistol is the same as a small rifle in ability to ignite powder in a small case like a 30 carbine or say a .22 Hornet.

RED
01-07-2016, 03:46
After pondering it... Is it possible that a considerable amount of the powder in a pistol, exits the barrel and is not burned but does burn in the longer rifle barrel. Which begs the question, if it don't burn, why use it to start with?

Litt'le Lee
01-07-2016, 07:03
you may find that a modern pistol will have a higher pressure rating than a lever gun

emmagee1917
01-08-2016, 07:55
Burning rate is for the time it takes for the complete granule to burn . If you get , say , an 80% burn , well , 80% of a lot is much greater than 80% of a little .
Chris