Doesn't make sense!

[S.A. Boggs]

My Black and Decker cordless screwdriver battery [Versapak] finally gave up the ghost. Cheaper to buy a new Black and Decker cordless screwdriver then try and replace the battery. I use the screwdriver to power my case trimmer.
Sam

[dryheat]

Been that way for about twenty years; where ya been?

[Major Tom]

What makes me mad is when the charger for the batteries gives up. And, when a battery won't recharge there are no replacement batteries available.

[S.A. Boggs]

Been that way for about twenty years; where ya been?
Working full + hours at a mental health facility.:icon_e_confused::eusa_wall::icon_bounce:
Sam

[Jim in Salt Lake]

The upside of getting a new tool is that you might end up with a much better battery, especially going from ni-cad to lithium ion.

[Allen]

The upside of getting a new tool is that you might end up with a much better battery, especially going from ni-cad to lithium ion.

+1 on that. Plus the lithium batteries have no memory and produce more voltage per weight/size.

[clintonhater]

Plus the lithium batteries have no memory...

What does this mean, exactly. Have been told, for ex., that leaving a 12v battery pack (ni-cad) plugged into the charger all the time reduces its capacity to hold a charge.

[Allen]

All ni-cad batteries have a memory. I don't know if the trickle charge from being left in a charger continuously affects them much. When we use a light or tool powdered by the ni-cad's we recharge them when we get finished or when the power starts to diminish. After a while this top portion of the charge is all the battery sees and holds a lesser charge. Some people state that ni-cad's should be fully discharged before recharging for this reason but I haven't found it to help any, maybe because I don't do it every time. On the lithium batteries it makes no difference and they hold a charge much longer. All cell phones, lap tops and electric cars are lithium charged now I hear and more and more tool makers are doing away with the ni-cad technology. I have tools that use the ni-cads and have had good service from them but the batteries are much larger than the same or greater voltage lithium's.

https://sciencing.com/lithium-batteries-vs-nicad-batteries-5939109.html

http://homeshowradio.com/nicad-vs-lithium-ion-cordless-tools/

[Former Cav]

buy a new sears lithium powered hand held drill. works great and holds a charge forever.
or....buy a monodnadnock tool which cuts the length, chamfers the ID and OD in ONE pass.
if you want to know where to buy one for roughly 30 bucks.....email me via private message and send me your standard email address and I will send you a jpg and the contact info.
HTH
Bob
PS. I used to do the same, chuck up my RCBS case trimmer in a vise, and then the B&D battery drill with those ROUND batteries.

[Sunray]

Way longer than 20 years, but planned obsolescence is a factor too. The days of manufactured stuff lasting years and years(like my Ma's Frigidaire) are long gone.

[dryheat]

I had a camera that used Ni-cads. It drove me crazy. It lost power after a few minutes of use. I finally got some instruction on how to use it. When the charge got close to empty there was a setting on the camera that would completely discharge the batteries. Then you put them in the charger. Made a huge difference. But still a pain to use. I called it the "battery factory". I had three compartments for charged, need to discharge and discharged with a half dozen batteries in each compartment.

[Dick Hosmer]

Gee, my corded tools don't have any of those problems - and - they are handier, and less bulky, in tight places. :icon_scratch: