Richard H Brown Jr
01-11-2018, 11:38
Dear Ffolks:
Need to find a Garand surgeon for a guy in Shelby Charter Township, MI. He's got a problem with not being able to zero his garand.
He uses a center hold and it hits 12 in high at 100yrds with the elevation completely forward. I've told him to 1. Disassemble and check the sight parts using the Rear Sight Disassembly instructions at CMP. And get a complet set of rear sight bits from Sarco, Numrich, in case there's a pinion problem with the sights. I also suggested he get a front sight and front sight screw, and use a micrometer to check that the front post hasn't been fiddled with. the 3rd choice I suggested is that either the barrel is shot out, or the crown is buggered. But since he says the rifle gives good groups, so I don't think it's the crown. I *SUSPECT* that it's either the front sight blade height, or the rear sights are gummed up, But there's also the chance that if the barrel had been replaced the facing geometry of the barrel threads and the receiver are off. Any suggestions further? He's on the Garand group on arse parchment.
R Brown
Need to find a Garand surgeon for a guy in Shelby Charter Township, MI. He's got a problem with not being able to zero his garand.
He uses a center hold and it hits 12 in high at 100yrds with the elevation completely forward. I've told him to 1. Disassemble and check the sight parts using the Rear Sight Disassembly instructions at CMP. And get a complet set of rear sight bits from Sarco, Numrich, in case there's a pinion problem with the sights. I also suggested he get a front sight and front sight screw, and use a micrometer to check that the front post hasn't been fiddled with. the 3rd choice I suggested is that either the barrel is shot out, or the crown is buggered. But since he says the rifle gives good groups, so I don't think it's the crown. I *SUSPECT* that it's either the front sight blade height, or the rear sights are gummed up, But there's also the chance that if the barrel had been replaced the facing geometry of the barrel threads and the receiver are off. Any suggestions further? He's on the Garand group on arse parchment.
R Brown