PDA

View Full Version : Hornady customer service


S.A. Boggs
05-08-2018, 11:39
Called a couple of weeks ago to order a replacement pan for my 50 year old "Pacific" scale, was told no parts available. Figured that I would need to order a new scale and advised the lady that Graff's was out and that I ordered ONLY from Graff. She said that she would see what she could do, today got a replacement pan that fit the wire on my scale perfectly...just one problem. When I tried to set zero as usual it would not, wasn't close. It wasn't a problem to use the adjustment on the balance bar as the replacement pan was much lighter then the original. Will check the actual accuracy against known weights and my electronic scale.
Sam
leftyo
05-08-2018, 09:16
ive only ever called their CS one time, and had a good experience.
bdm
05-11-2018, 12:40
Look on Ebay i have pacific reloading tools sometimes you can find cheap pacific parts or the whole scale cheap.I just picked up a trimmer for $10.00 not to long ago.
Allen
05-11-2018, 02:45
For some reason those little pans are expensive for what you get regardless of brand.
Allen
05-11-2018, 03:38
the replacement pan was much lighter then the original.

If the pan is made of steel could you cut a rubber refrigerator magnet as needed for weight and attach it under the bottom of the pan? If not steel then glue something under the bottom? Kinda a red neck way of doing things but it may buy you some time till you find what you need.
Merc
05-18-2018, 08:03
To permanently add some extra weight, apply some epoxy to the bottom of the pan. It doesn’t usually require much weight. Add or remove the epoxy while it’s still soft until you achieve balance. To fine tune the balance, let the epoxy harden and then either add more or file off the excess until the balance can be calibrated.
free1954
05-20-2018, 04:32
To permanently add some extra weight, apply some epoxy to the bottom of the pan. It doesn’t usually require much weight. Add or remove the epoxy while it’s still soft until you achieve balance. To fine tune the balance, let the epoxy harden and then either add more or file off the excess until the balance can be calibrated.


+1