M1A Flash suppressor Swap [Archive] - Jouster2 Shooting Forums

View Full Version : M1A Flash suppressor Swap

Major Tom

11-08-2018, 02:39

I am looking at a Springfield (Geneseo,Ill) M1A. The flash suppressor does not have the bayonet lug. Can a GI suppressor w/lug be swapped out on this rifle? Thanks for replies

Ted Brown

11-08-2018, 02:53

Yes, GI flash suppressors will fit on the M1A.

lyman

11-08-2018, 04:44

absolutely, quick and easy swap

Allen

11-08-2018, 04:52

Some use an alignment tool to make sure the suppressor is perfectly straight. Some are bored out to about 3/8" or so for extra clearance. I'm sure nf1e can enlighten on the subject.

lyman

11-08-2018, 04:55

the ones that are bored (actually reamed) are usually done for Match Rifles,

nf1e

11-08-2018, 05:54

Yep, direct swap but be careful that the current FS is not welded in place.
NM suppressors are taper reamed for better clearance.
An alignment too is a good idea when installing a standard FS.

Allen

11-08-2018, 06:33

Yep, direct swap but be careful that the current FS is not welded in place.

Does anyone other than Polytech and Norinco weld the castle nut to the FS? BTW, the Chinese castle nuts have a different thread (metric I'm sure) from the U.S makes.