Taylor's M1885 hi wall

[kj47]

Didn't know where else to post this, picked a hi wall at LGS. Double triggers 45-70 32in bbl octagon. Will be shooting black or substitute only(just because) Overall very good finish. trigger tune up as they are a little gritty, rear trigger is alittle hard to set. Front one can only be used if set by rear one. One heavy gun, Can't wait to shoot it!

[RCS]

Really nice to find a Hi Wall that you can shoot, Winchester made nice double set triggers
too. I found an action with double set triggers and a coil hammer spring in Detroit and a
Darr extra heavy 32-40 barrel in Calif. Also bought a Hoch nose pour mould of the correct
diameter so that you don't need to size the bullets. Bullets are breech seated into the barrel
and you use a single 32-40 case each time 49708497094971049711

[kj47]

Looks to be a real nice hi wall. Good shooting I'll bet. Don't know if I'll go with veneer sight or optics, depends on how I do with it.

[RCS]

If you have an original Winchester barrel, without scope block holes, i don't think I
would drill new holes. Alot of tang sights available now, Years ago I made a tang
sight for a heavy barreled Remington rolling block in 45-70, used black powder and
either 405 gr or 500 gr lead bullets

[kj47]

This is a uberti imported by Taylor's. I have uberti revolvers really like them. Good quality and one third the price of a Colt. I'll probally get trashed for saying that. Beleave me I would like a Peacemaker.