1879 Carbine Cleaning Rod Section [Archive]

View Full Version : 1879 Carbine Cleaning Rod Section

Wade

11-23-2021, 10:36

I bought a 1879 Carbine and when I opened the butt plate compartment, there were 2 rod sections inside. One has the end tip and the other has the threaded barrel end on it. I need one middle Cleaning Rod Section to complete the rod assembly. Please let me know if anyone has an original section to part with.

Tom Trevor

11-23-2021, 10:47

And you also need the early shell extractor with the three prongs that the center rod goes thru it the buttstock.

Wade

11-23-2021, 12:10

Hi Tom,
yes, I need the extractor also.

49854

JimF

11-23-2021, 12:30

Look here for the AUTHENTIC parts:

The U.S. Springfield Trapdoor Rifle Information Center (http://trapdoorcollector.com/)

scroll thru to the appropriate section.

Wade

11-23-2021, 12:35

I have checked there, but they only have 3 piece sets for sale.

Dick Hosmer

11-23-2021, 12:39

I'll check, I might have an extra rod - do not have a surplus extractor.

Wade

11-23-2021, 12:52

The center hole in the butt stock is 2" deeper than the outer holes. Also the rear sight screws are very buggered and very tight. Is it worth the effort to replace them or should I leave well enough alone?

498554985649857

Tom Trevor

11-23-2021, 03:01

Screws are available from parts dealers. trapdoorcollector.com parts page for one. Deeper hole is for tool and rod also note center hole larger diameter to fit tool at butt end.