View Full Version : Pulling parts together for another rifle.
Have a new Bula standard M14 receiver with bolt and usgi profile 19.5" barrel. This will be kinda enjoyable. Have not put a standard together in some time. There are quite a few stocks to choose from in the stash. I am thinking of maybe one of the T44 stocks with the M1 butt plate. Will see what happens as progress is made. Looks like plenty of small parts in the drawers, trigger groups, op rods, sights and flash suppressors. Just need to decide which will make it onto the project. Whatta Hobby!
5262752631526285262952630
Had a few minutes this morning so I nailed her together. Found a real nice USGI fiberglass stock on the rack so here she is as a newborn. Decided to use an 19.5" barrel so I edited the OP. Nice to have choices. Whatta Hobby!
526375263852639
I have a 'bush' barrel, (18 or 19 inches tucked away somewhere, and an Alpini Stock
thoughts were to rebarrel my M14 (NFA) and put it in that stock,
likely brutal to shoot, , and it is way way on the back burner of things to do
I have a 'bush' barrel, (18 or 19 inches tucked away somewhere, and an Alpini Stock
thoughts were to rebarrel my M14 (NFA) and put it in that stock,
likely brutal to shoot, , and it is way way on the back burner of things to do
I am getting old enough to know better than leave anything on the back burner. Maybe save for the next lifetime, if such a thing actually exists. It's all good. That receiver, bolt and barrel came in less than 24 hrs ago and is ready for the range. Now, I may put that off for an hour or two. Whatta Hobby!
Update. This time I am doing a before accuracy enhancements and then another after updating the rifle. Right now it is just a plain M14 in a USGI fiberglass stock with regular trigger and non-unitized gas system, no shims either. No stock work at all. This is what one might expect direct from Bula Defense Systems for a standard build. This barrel is NATO headspaced to 1.636. Ammo is hand loaded 135 gn Sierra varminters. Fired 50 rnds of MEN German surplus rapid fire for function test and to warm things up nicely. Then switched to home brew ammo and fired for a 10 rnd 100 yd group. Max spread is right at 1.25 moa. Well within 10 dot challenge accuracy before any additional work. Whatta Hobby!
52677
Whatta Hobby! Man you can say that again!!! Sincerely. bruce.
Update. 19.5 used barrel was not doing what I wanted so I changed it out today for a Bula Defense Systems Heavy 1/10 22". Rifle is now bedded in a NM Walnut stock and looks promising. Ran 100 rnds dow range this afternoon to settle things down. Shot this MR-31C as my last target of the day. X ring is 3/4". So 6 hits on the X ain't too shabby for a dinosaur. Whatta Hobby!
52745527465274752748
You have a winner there, Sir.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.