so i can adjust the offset screw and bore sight the scope?
thx,
goo
m1d-3.jpg
so i can adjust the offset screw and bore sight the scope?
thx,
goo
m1d-3.jpg
Last edited by goo; 01-12-2016 at 03:13.
"I eat concertina wire and piss napalm and I can put a round up a flea's ass at 200 meters."
the big knob. i needa remove it the tweek the itty bitty offset correction screw
"I eat concertina wire and piss napalm and I can put a round up a flea's ass at 200 meters."
how do i remove the big knob?
offset.jpg
"I eat concertina wire and piss napalm and I can put a round up a flea's ass at 200 meters."
this might explain the problem but i don't see an answer,
http://garandforum.proboards.com/thr...ignment?page=1
"I eat concertina wire and piss napalm and I can put a round up a flea's ass at 200 meters."
are you talking about the locating pin that is next to the mount screw?
https://images.search.yahoo.com/imag...t&type=sbc_dsl
Last edited by StockDoc; 01-12-2016 at 06:29.
liberum aeternum
this will probably help you some "How to set a mechanical zero on the M84"
https://www.youtube.com/watch?v=sqQrkTrWq5U
liberum aeternum
not a screw but a locating pin, it does not move
But I have thought about removing the pin and putting a set screw there, or a fine Diamond hone to adjust. Until then, I had good luck using this video and a laser bore sighter. https://www.youtube.com/watch?v=sqQrkTrWq5U
Hope this helps
Last edited by StockDoc; 01-12-2016 at 06:43.
liberum aeternum
that was very helpful. thank you so much, stock doc.
"I eat concertina wire and piss napalm and I can put a round up a flea's ass at 200 meters."
welcome
liberum aeternum