Parts for Anscutz 1516D in .22 WMR

[Liam]

My last resort. Days of online searching and contacting various companies led to naught. The one place I found that possibly had the parts was in Australia and they cannot ship to US.

I have a nice Anschutz 1516D in .22 WMR that will not eject spent cases. I narrowed it down to two missing parts, as shown in attached images. Anschutz only supports rifles from last 5-7 years of manufacture, so they (and Merkel) are no help.

Just throwing this out there. Thank you for reading. - Liam
1516D_Pic2.jpg
1516D_Pic.jpg

[PWC]

Do you have #34? Looks like #33 holds #'s 32 and 34 down. May have to make and fit #32 if you can get a blow-up drawing. Home Xepot Graingers, McMasrs have metric screws: may have to buy a range of sizes.

[Liam]

Do you have #34? Looks like #33 holds #'s 32 and 34 down. May have to make and fit #32 if you can get a blow-up drawing. Home Xepot Graingers, McMasrs have metric screws: may have to buy a range of sizes.

Yes, I have that. It is the bolt guide. Not sure if simply finding the correct size/thread screw is the answer. Somehow that screw acts as the ejector, as well as holding the bolt guide in place.

[Allen]

Did you look here?

https://www.gunpartscorp.com/catalog...=Anscutz+1516D

[PWC]

Goodo Allen!