Pallet ceiling started

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • S.A. Boggs
    Senior Member
    • Aug 2009
    • 8568

    #1

    Pallet ceiling started

    20181105_115442.jpg
    Started on the ceiling and the "rustic" look will fit in with the 1880's décor.
    Sam
  • bruce
    Senior Member
    • Sep 2009
    • 3759

    #2
    Looking good! Going to be nice! JMHO. Sincerely. bruce.
    " Unlike most conservatives, libs have no problem exploiting dead children and dancing on their graves."

    Comment

    • Major Tom
      Very Senior Member - OFC
      • Aug 2009
      • 6181

      #3
      I noticed that there is no vapor barrier on the ceiling insulation. You have it on the walls tho.

      Comment

      • S.A. Boggs
        Senior Member
        • Aug 2009
        • 8568

        #4
        Originally posted by Major Tom
        I noticed that there is no vapor barrier on the ceiling insulation. You have it on the walls tho.
        Had it picked out at Lowes not knowing what I was given. Had two of the rolls opened up before realizing their mistake, so I had to use it anyway. If you look above I have a plastic barrier below the metal room, that barrier was expensive but much better then tar paper.
        Sam

        Comment

        • bdm
          Senior Member
          • Sep 2009
          • 613

          #5
          Sir very nice pallet lumber is 1-2 and 3 common oak

          Comment

          • Major Tom
            Very Senior Member - OFC
            • Aug 2009
            • 6181

            #6
            My experience is that the vapor barrier should be on the warm side of room so that insulation doesn't get wet from condisasion (sp).

            Comment

            • S.A. Boggs
              Senior Member
              • Aug 2009
              • 8568

              #7
              Originally posted by Major Tom
              My experience is that the vapor barrier should be on the warm side of room so that insulation doesn't get wet from condisasion (sp).
              Agreed so I am looking at other ways to overcome this.
              Sam

              Comment

              Working...