Tweet
I am currently finishing fitting of a Dupage laminated to one of my M1's.
I have had to remove about .010" from the leg area, it appears the cutters were not set right.
I say that because a different part of the cut another operation done correctly blended in perfectly when I removed the excess wood.
I am having to bed under the rails because there is not enough wood present to lock up properly
A .005" shim will pass under the entire length of both rail sides,
that is with the heel in contact and the proper location for the barrel relative to the stock furrel.
The front underside of the trigger housing will need bedding also.
I have had to remove about .010" from the leg area, it appears the cutters were not set right.
I say that because a different part of the cut another operation done correctly blended in perfectly when I removed the excess wood.
I am having to bed under the rails because there is not enough wood present to lock up properly
A .005" shim will pass under the entire length of both rail sides,
that is with the heel in contact and the proper location for the barrel relative to the stock furrel.
The front underside of the trigger housing will need bedding also.
Comment