Gunsmith for a Remington model 10

[colt thompson]

I picked up a US marked model 10 and the take down latch doesn't want to move. I've been soaking it with penetrating oil for several weeks. I'd like to find a competent gunsmith to send it to

[mtrpdw]

Try heating up the area with a [paint remover] heat gun - it won't alter the finish.

Then try tapping the area with a non-marring hammer and punch - might help in loosening the crud the penetrating oil can't get to.

I suspect this is exactly what you'll pay a gunsmith to do.

I've had good luck with this on assorted stubborn items.

Cheers!

[RED]

Try this gunsmith... He is very reasonable pricing and has a short turnaround time of days, not weeks or months.

Matt Parker
573-289-2493

[colt thompson]

Try heating up the area with a [paint remover] heat gun - it won't alter the finish.

Then try tapping the area with a non-marring hammer and punch - might help in loosening the crud the penetrating oil can't get to.

I suspect this is exactly what you'll pay a gunsmith to do.

I've had good luck with this on assorted stubborn items.

Cheers!

Thanks, I'll give it a go

[scosgt]

Another old gunsmith trick:
Go to Radio Shack and buy a spray can of Component Cooler.
Spray the head of the part you need to remove until it is solid frost.
Then tap it lightly with a hammer.
The spray will cool it to about -50 degrees and it will contract and may turn right out.