Parts for Anscutz 1516D in .22 WMR

[Liam]

My last resort. Days of online searching and contacting various companies led to naught. The one place I found that possibly had the parts was in Australia and they cannot ship to US.

I have a nice Anschutz 1516D in .22 WMR that will not eject spent cases. I narrowed it down to two missing parts, as shown in attached images. Anschutz only supports rifles from last 5-7 years of manufacture, so they (and Merkel) are no help.

Just throwing this out there. Thank you for reading. - Liam
1516D_Pic2.jpg
1516D_Pic.jpg

[PWC]

Do you have #34? Looks like #33 holds #'s 32 and 34 down. May have to make and fit #32 if you can get a blow-up drawing. Home Xepot Graingers, McMasrs have metric screws: may have to buy a range of sizes.

[Liam]

Do you have #34? Looks like #33 holds #'s 32 and 34 down. May have to make and fit #32 if you can get a blow-up drawing. Home Xepot Graingers, McMasrs have metric screws: may have to buy a range of sizes.

Yes, I have that. It is the bolt guide. Not sure if simply finding the correct size/thread screw is the answer. Somehow that screw acts as the ejector, as well as holding the bolt guide in place.

[Allen]

Did you look here?

https://www.gunpartscorp.com/catalogsearch/result/?q=Anscutz+1516D

[PWC]

Goodo Allen!

[Liam]

I found that, ordered that, and discovered it doesn't fit. Part is mislabeled. Must fit a similar Anschutz, but not mine. Have since found a Canadian parts supplier that has what I think I need. Will follow-up, if successful.

[Liam]

I now know the part name I am seeking. "Anschutz Magazine Retainer Screw & Nut." Found this set online, but for the 1416 (.22 model). Recall, mine is in .22WMR. Working with several online stores, but even they agree that Anschutz parts for older guns are hard to come by. In this design, the "retainer screw" also acts as the ejector on my rifle. Need all 3 in pic. Screen Shot 2025-02-08 at 2.14.24 PM.jpg