pulling bullets in M2 .30 cal

[Ltdave]

No. It's the same. Are you inserting the wrong end first? (Tapered end goes down to mate with cone at bottom of die.)

Standard Bullet Puller for standard 7/8"-14 presses.

The Forster Collet Style Bullet Puller fits any 7/8" X 14 thread reloading press and bullets from .17 caliber to .458 caliber. Must be used with Forster Bullet Puller Collets.

https://www.youtube.com/watch?featur...&v=f98-ab9DDr8

yep. it seems to be maybe a little bit flared on the "bullet-in-end" and theres definitely at raised lip on the other end. ill post a picture shortly...

[Ltdave]

i squeezed the collet closed a little bit in my vice and then it fit fairly easily...

after i got the thing adjusted it was a piece of cake...

i had some VERY wide spreads on powder charges. i pulled some clips apart and out of 20 rounds i had charges running as high as 52.3g and as low as 43.8g on the first 10 i weighed and then i only had 8 with the same type powder (a short JET BLACK extruded stick ) with 2 rounds that had a very fine black ball powder in the 57g range...

i pulled down 2 boxes of the brown box ammo and it was the same extruded stick and while closer in weights still a 0.7g spread...

this was all LC 68 i had gotten from CMP...