I've read mixing liquid lanolin and 99% isopropyl alcohol works very well. Try this link for more info: http://www.frfrogspad.com/homemade.htm#Sizing
Emergency case lube
Collapse
X
-
I've been sing Mink Oil Boot Dressing (cream). I got it at my local Walgreens and have been using the same jar for 3 years. A dab on my fingers, roll the case around to get a thin film, size. Clean up is as easy as wiping with a paper towel, and my hands stay so soft and smooth...
Last edited by mikld; 02-07-2015, 10:12.Comment
-
I used PAM once... After sizing, I just soaked them in a sink full of dish soap, rinsed, and allowed them to air dry for a day. Worked great and I had no problems!"I was home... What happened? What the Hell Happened?" - MM1 Jacob Holman, USS San PabloComment
-
Be careful, hair will grow on your fingertips..........It took a while since the move to Portland, but I was out of 45-70 and finally had to set up. I rummaged around and found most of what I needed except for case lube. Crap! Portland is not exactly rife with gun shops ... I was thinking of going to Cabelas, but it"s a 2-hour round trip. Tried to think what I had around the house that would work ...olive oil? ... WD40? ... naah. Then I remembered the KY sex lube. They call it Silk-E. It is water soluble and non-toxic.
I used it to decap and size all my brass, no problems whatever. I quick rinse under warm water and it was gone, then 15 minutes in the oven at 225 and they were ready to prime. It was way easier to deal with than the RCBS stuff I usually use. The stuff worked pretty well with 45-70 brass. Should be fine for pistol brass and straight-case BP rounds. I think I'll give it a shot with heavier shells, like 30-40 and 7 mag. See if it works.
jnComment

Comment